Amana Tool 51324 Carbide Tipped Opposite Shear Staggered Shear Tooth Plunge 1/2 Dia x 2 Inch x 1/2 Shank pads cutting edges additionally induction hardened

cutting edges additionally induction hardened to approx

100% Duty-Cycle Motor

Largest diameter bits should be run at reduced speed

Captures particles down to five microns in size and acts as a pre-filter

which has the cove coming off the bearing

Amana Tool 51324 Carbide Tipped Opposite Shear Staggered Shear Tooth Plunge 1/2 Dia x 2 Inch x 1/2 Shank pads cutting edges additionally induction hardenedA stagger tooth bit has two cutting edges, each only half the flute length, located 180 apart, one high, one low. The result is a tool that combines the speed and chip clearance of a one flute bit with the strength and balance of a two flute bit. This "opposite shear" configuration features a down shear edge and an up shear edge. On a through cut, it shears down on both surfaces at the same time. It is excellent for working double sided melamine,