Amana Tool 49554 Carbide Tipped Table Edge Ogee 3/8 Radius x 2-1/2 Dia x 3/4 x 1/2 Inch Shank chalk Our No-File™ bit "breaks" the

Our No-File™ bit "breaks" the sharp edge as it trims the laminate flush

An edge bead without a quirk is produced by this bit

Hard pad for sanding flat surfaces and narrow edges

plug connectors and butt connectors

Pockets & Tool Holders: 25

Amana Tool 49554 Carbide Tipped Table Edge Ogee 3/8 Radius x 2-1/2 Dia x 3/4 x 1/2 Inch Shank chalk Our No-File™ bit "breaks" theCuts a shallow ogee into the tabletop surface coupled with a bead at the edge. Bit will produce a fillet if set to cut deep enough. With the optional 3 8" bearing, it will produce a fillet at the cut's edge. Good choice for handrails. These special router bits are used for cutting table top edges or used with handrail side profile bits. Originally designed for easing and profiling the edges of tabletops, these bits also are widely used for the same