Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with modular taper interface with ball track system PAS 015 For unplated parts the method

For unplated parts the method is non-destructive

during installation and in the stage of pouring concrete

BS EN 2542 specifies the requirements relating to:

Instruments that conform to this part of BS ISO 21501 are used for the classification of air cleanliness in cleanrooms and associated controlled environments in accordance with BS EN ISO 14644-1

BS 6465-2 provides relevant

Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with modular taper interface with ball track system PAS 015 For unplated parts the method1 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with modular taper interface (TS) with ball track system. The relationship between symbols in this part of ISO 10649 and the ISO 13399 series is given for information in Annex A.