Ceramic tiles. Grouts and adhesives - Test methods for grouts Ingestion-build-46800 NOTE 1 It is the

NOTE 1 It is the responsibility of the purchaser or specifier to make the appropriate selection from these aspects

and gives guidance on

The sorbent tube approach is intended for use under relatively low particulate conditions (typically less than 100 mg/m3) when monitoring downstream of all pollution control devices

The procedure

Figure 2 — Target domain of the data quality model

Ceramic tiles. Grouts and adhesives - Test methods for grouts Ingestion-build-46800 NOTE 1 It is the1 Scope This part of ISO 13007 describes methods for determining characteristics for grouts used in the installation of ceramic tiles. The following test methods are described: determination of flexural and compressive strength (4. 1); determination of water absorption (4. 2); determination of shrinkage (4. 3); determination of resistance to abrasion (4. 4); determination of transverse deformation (4. 5); determination of chemical resistance (4. 6).