AS5000 Sensor T121406 it is necessary to resend

it is necessary to resend the data to FR-811

Large lineup ranging from general-purpose type to purpose-specific type

The holding mechanism eliminates the need to manually pull and withdraw a new wick after cutting

Feeder Pen

10 mm × 10 mm) B2410 Φ75mm×2m Duct B2416 Duct Band (2 pcs) B2418 Bench Top Plenum/Clear Parts Required For Independent Ducts

AS5000 Sensor T121406 it is necessary to resendReplacement for 191 212. 1 piece It is recommended to replace the sensor, AS5000, after 1,500 measurements. However, the timing may vary depending on the tip temperature, solder, and flux. Caution: The sensor is very thin and may break if pressed hard. Measure tip temperature faster and with higher accuracy Approximately 30 times longer than conventional sensors (based on in house tests) Temperature measurement of conventional sensors degrade after 50